1.gif (818 bytes)  

  

  To turning off & on the Step-by-step identification mode
 

In the programme the Step-by-step identification mode is on by default.

During this mode the programme starts the identification process immediately after confirmation the character state selection.

When the Step-by-step identification mode is off, then indicator inside the Starts identification button is red Indicator-Red.gif (920 bytes),
if the mode is on, then indicator is green Indicator-Green.gif (905 bytes)

 In order to turn off the Step-by-step identification mode:
N-1.gif (152 bytes) Click on the green indicator Indicato-S-Red.gif (900 bytes) Turns off step-by-step identification, which is arranged inside the Starts identification button - indicator will change colour to red,
       If the Step-by-step identification mode is off, then you may repeatedly select characters and select in their the state, to start whole identification process after.

In order to turn on the Step-by-step identification mode, click one of the above-mentioned points again.