First step Identification


Draw your attention that at the right of the character arrange the numeral, which to indicate the number available states in this character. At the beginning of determination we recommend you use that character, which have not many state.	To select character:
		Into the Available characters window click on a character formulation, on the right the field will be displayed with note and figure explaining the character.
	If you decided, that chosen character is appropriate, you should open the Available states window :
		Double-click on the character formulation into the Available states window, Or: Click the Goes to the state setting mode button, which is arranged in the lower row of the right lower bar. The Available character window moves to the left, and the Available states window is displayed at the right.
	To select character state: In the Available states window you see the states formulations and their illustrating images, you may select one or some characters states, which are appropriate for you:
		In the state formulation field click in the empty Check-box, which is arranged at the upper left corner. The check mark is created in it. You may use the buttons which are arranged in the lower row of the right lower bar: Select all Claer all
		To confirm your selection and click the Confirms character state selection button, which is arranged in the lower row of the right lower bar, You may escape selection and click the Cancel character state selection.
	So as by default in the programme the Step-by-step identification mode is on, then after confirmation the character state selection the programme starts the identification process immediately. In this case you may not do following point. Turning on and off the mode of Step-by-step identification look topic: Step-by-step identification mode If the Step-by-step identification mode is off, then the programme closes the Available states window and the section returns to primary form and you should start the identification process:
		Click the Starts identification button, which is arranged in the upper row of the right lower bar. After the programme leaves exactly those taxa names, which are appropriate for the description made by you. Above available characters you will see Diagnosis, where will be enumerated the characters and their state selected by you. After first identification step the programme makes re-evaluation available character and leaves only that characters and in them only that state, which are appropriate to left and identified taxa name. All these processes may take a time.